How many wear stages do the amusement rides during use?

To be sure that the amusement rides must be worn, then what we can do to slow down the speed of its wearing, and how many wear stages do they have?

First period, Running-in period.

At the very beginning, the new appearance is a little bit rough, and the practice touching area is very small, so its rate of wear is very quickly. But as time goes on, continuous wear will make the surface of the ride become smooth, practice touching area gradually increases, its surface will be smooth enough. Most importantly, the wear rate is gradually reduced. When it reaches some degree, it tends to settle down. The amount of wear during this period is called the early grinding.

During this period, on the equipment without running-in, should abide by the provisions of load reduction, deceleration, reasonable operation, add viscosity lower smooth oil, as far as possible constant temperature. In addition, in order to shorten the running-in period can choose the appropriate advanced technology, and improve the utilization rate of equipment. After running-in, clean the smooth system, use the smooth oil that conforms to the quality request.

Second, stable wear stage

When the ride runs for a long period of time, the surface become hard, just as the same as the strength test. The results showed that this effect was obvious and the reason is that there exists work hardening in the surface layer or residual stress. During the latter part of the period, because of metal fatigue, wear is relatively accelerated, but can still be maintained. When close to the fatigue limit of the metal, the machine will be regularly forced to repair, in case the machine because of excessive wear and tear to form a mechanical disturbance.

Third period: Severe wear stage

During this period, because the metal surface layer to reach the exhaustion limit, the conflict condition attack big change (such as the sharp increase of temperature, the surface metal arrangement significant alteration, microcosmic dash shape change, void increase, smooth strip and so on), causes the wear speed rapidly, the mechanical efficiency reduces and the parts fail, then you must change it and repair.

Know clearly about these information can help you protect your amusement rides. Sinorides is a professional amusement rides manufacturer, and there are many kinds of rides in our company, such as carousel rides, train rides (track train rides and trackless train rides), self-control planes and so on.