→ MACHINE DRIVEN SYETEM
Another one small problem about the motor, that is unable to start again. That's very eave to solve. First you need to check the relay protection (Buchholz relays have a test port to allow the accumulated gas to be withdrawn for testing). Then you should know the voltage, the low voltage can not make the ride work.
This time, let's talk about the speed reducer. If there is something wrong with it, the temperature will be higher than usual. In general, that's because the ride are taking too many people. But sometimes, you should add lubricating oil to the reducer. According to the survey, poor lubrication is premature damage caused by one of the temperature's change. Stop the ride to check if there is any abnormal noise or vibration during operation.
The following are about different drive systems.
1.V-belt drive
This kind of transmission model, you should be careful of the belt. If it's too tight, it would be wore quickly; there will be elastic sliding, when increasing work load, the elastic sliding zones (i.e., elastic arc) will expand to the whole contact arc, slip occurs at this time In the tape drive, should try to avoid the occurrence of slippage.
2.Chain drive (most amusement carousel rides fit in this category)
Two chain wheels are not in the same level, you need to adjust the position of the chain wheel, or the ride will be unstable. And catenary sag's incorrect set will make the ride operate unsteadily. In addition, rope drive has the same problem with the chain drive. You can refer to its methods to solve the problems.
To be continued
No comments:
Post a Comment